Tap & Go Head M10
A budget bump-feed line head with an M10 thread, letting you release fresh line by tapping it on the ground rather than rewinding by hand.
You'll be sent to Amazon in your country. Indicative price — live, localised pricing where available. As an Amazon Associate we earn from qualifying purchases.
Pros
- Very low price for a straightforward, functional line head
- Simple to reload and easy to strip down for cleaning
- Copes fine with lawn edges, borders, and light garden grass
Cons
- M10 fitting only, so it won't suit trimmers with other thread sizes
- Plastic housing feels less durable than branded equivalents
- No blade option, strictly a line-only head
What it does
This is a basic bump-feed trimmer head built around an M10 threaded fitting, one of the most common shaft sizes on domestic and semi-professional strimmers. Rather than manually unwinding line or relying on an automatic feed sensor, you tap the spinning head lightly against the ground and a short length of fresh line is released from the spool. It’s an inexpensive, no-frills way to keep a trimmer running without stopping to rewind, and the mechanism is simple enough that most home users can strip it down and reload it themselves in a couple of minutes.
Loaded with line up to 2.4 mm, it’s aimed at everyday garden tasks: trimming lawn edges, tidying around borders and paths, and clearing light grass. It isn’t intended for anything heavier, and the housing is a fairly basic moulded plastic rather than the reinforced nylon used on some pricier heads, so treat it as a budget-friendly option rather than a long-life replacement part.
Fitting and choosing
Before buying, confirm your trimmer’s drive shaft actually takes an M10 fitting — this is a widely used size on many cordless and petrol models, but far from universal, and some machines use M8, M10x1.25 left-hand, or other thread patterns entirely. Fitting the wrong thread either won’t screw on at all or, worse, can work loose in use, so check your existing head or the trimmer’s manual rather than guessing from the model name alone. Thread direction matters too: some heads are left-hand threaded specifically so they tighten rather than loosen as the head spins, and mixing this up can mean the head backs itself off during cutting.
As with any bump-feed head, match the line diameter to what your trimmer is designed to run. Thicker line cuts coarser stems more cleanly but puts more drag on the motor, so don’t assume the maximum 2.4 mm capacity is always the right choice — lighter line is often kinder to smaller machines and gives a tidier finish on ordinary lawn grass.
Limitations
This head is line-only, with no fitting for blades, so anything beyond grass and soft weeds is outside its scope. The bump-feed mechanism can also over-release line if tapped too enthusiastically, and the plastic construction means it’s more likely to wear or crack over a season of regular use than a metal-reinforced head. For occasional trimming around a normal garden, though, it does the job at a price that makes replacement cheap if it does wear out.